Questions & Answers for: ic fault

...IC) HOW TO SERVICE Rx SECTION FAULT ? Solution for Rx section no network found fault nokia dct-3 technolagy 1,clean the pcb well and Rehot (if not ok follow one by one solutions) 1, give antenna ...

...fault with either audio power amp ic (IC 501) or power supply ic IC 502. As both said ICs get very got first remove bottom steel grill and with the power off and capacitors drained (shorted together ...

...fault with either audio power amp ic (IC 501) or power supply ic (IC 502). May also be the fan if it has one make sure it is clean and can spin freely. Hope this helps. Thanks My panasonic turns on ...

...system technics sc-dv150 showing fault f61 how do i stereo system technics sc-dv150 showing fault f61 how do i fix it f61 is a bad voltage code. I will probably need an output ic or a voltage

...Ic fault or horizontal output sync: signal from the LOT not reaches to the respective pin of that Ic. Check first whether the horizontal sync: signal from one pin of the LOT reaches to the sync: pin ...

...that side first. There will be 6 or 7 of them. Replace it all at the same time. it won't cost more. If the fault still perists IC is damaged, and should be replaced with same type and number.

...fault. If not, check all the surrounding electrolytic capacitors to this IC circuit. If found suspected, replace them. Still fault perists, replace the vertical output IC with same type and

IC-736 total failure whilst on air, fuse OK, nothing smelt burning etc, not over heated, no voltage surge, SWR was moderate but protected by APC circuit. Totally dead now. This radio has given 15 ...

...The technician said it is unrepairable =( What you need to ask yourself is Why did the IC burn out. You may risk replacing the ic and some other fault with the motherboard burns out the new

...IC fault. This is a very small IC; have 8 solder terminals, and can be located very near to the main system control-chroma IC. Check and replace it. Be sure to replace it with the same number printed ...