Questions & Answers for: Jeep Grand Cherokee iac sensor

...IAC sensor gets dirty. The IAC sensor is located on the top of the throttle body. If you refer to the throttle body as a clock, and picture the egde closest to the front bumper is 6 o'clock then the ...

Also test the throttle position sensor and the map sensor as either can cause similar problems. When working with the IAC, don't turn the valve end or it may not seat properly when you put it back in

...are low ..... ??? It is either your TPS (Throttle possition sensor) or your IAC valve (Idle Air Control). The TPS can be adjusted But the IAC has to be replaced. Both are not that expensive to

IAC) sensor/motor. This sensor is located on your vehicle's, throttle body. The purpose of this sensor is to control the car's idle under various operating conditions including ambient temperature. In

...IAC Valve or TPS Sensor or maybe fuel filter, any ideas? I would suspect the iac stepper motor may be dirty or plugged off when coming back to idle. I would try cleaning it and the throttle body at ...

where is the iac valve located on my 1999 jeep grand cherokee 6 cyl or v8 Removal & Installation 3.7L The Idle Air Control (IAC) motor is located on the side of the throttle body. Disconnect ...

...iac not working If you have not done so pull the engine codes or have someone do it.The codes will give you a good idea where to start otherwise the first place I would check is replacing the ...

...sensor it ran fine for the week. But now it's stalling again, what else could it be? I've had it diagnosed by car repair shops and autozone. You replace sparkplugs,plug ...

...IAC with a DMM...this will be in a chilton/Hanes guide. You can also spray MAF cleaner onto the MAF sensor within the MAF however, if the MAF goes out the car usually will not start. (Do Not spray ...

IAC motor...especially if its an aftermarket brand!! something like that even though the part is a little more expensive go with OEM jeep parts, especially electrical stuff. If you have a high idle at