Questions & Answers for: Dodge Dakota iac sensor

Ad

sensor harness from the IAC Solenoid (Rear of Throttle Body) Remove the two Torx-25 Screws Remove the IAC Solenoid (Be careful not to lose the rubber O-Ring) Spray some Carb/TB Cleaner in the IAC port

Ad

...sensor. I would start by checking the IAC, its cheap (cost you a bottle of throttle body cleaner) and easy. I read somewhere you can pull the harness off the MAP and if that fixes the problem, then ...

Ad

Question about 2004 Dakota

2 Answers

...Replaced thottle body sensor, did not take of the problem try fixing the idleing problem by replacing IAC ( Idle Air Control )sensor check the idle cable...you should be able to adjust it by a

IAC is sticking it sometimes cannot compensate fast enough to avoid a stall. The problem is aggravated by the Air conditioner clutch cycling on while stopping. You don't mention the check engine light

Question about 1998 Dakota

1 Answer

...IAC) sensor/motor. This sensor/motor is located on your vehicles, throttle body and is easy to access. The purpose of this sensor is to control the car's idle under various operating conditions ...

sensor and the iac valve because it was almost stalling and not shifting proper now my rpm's are about 1500 & 2000 how do I corect that on my 2002 dodge dakota 3.9 4x4 qua Just replaced the tp

...sensor -replaced, iac-replaced, pcm-replaced, throttle body cleaned. Now getting skim-key faults. Truck will start and run, then intermittedly dies. Any help? try a wireless control mod and a new ...

Question about 2005 Dakota Quad

1 Answer

...sensor. Test 2: Rough, Low or High Idle Speed Condition (Continued) Test 2 Chart Step Action Yes No 1 Step Description: Verify the rough idle or stall Does the engine have a warm engine rough idle, ...

...dead this morning I jumped it and now the starter cranks a little slow and it will not idle but runs fine if you keep your foot on the gas Try replacing the iac sensor tps sensor if equipped with

...When you let off the gas, it acts like it is trying to shut down. I replaced the cam sensor, but it did I can't figure it out. Why you replaced cam sensor,you should replace TPS sensor or IAC

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2001 Dodge Dakota
2001 Dodge Dakota

995 Questions

1998 Dodge Dakota
1998 Dodge Dakota

851 Questions

1997 Dodge Dakota
1997 Dodge Dakota

695 Questions

1995 Dodge Dakota
1995 Dodge Dakota

711 Questions

1992 Dodge Dakota
1992 Dodge Dakota

605 Questions

Manuals & User Guides

Loading...