...sensor the adjustment is controlled by the computer there is no adjustments.What kind of problem are you having? if it is stalling then i would replace the iac if you have then check the battery a ...
IAC or vacuum hose leak the O2 sensor will see this extra air and add fuel to compensate to maintaim a 14.7 to 1 ratio but also the computer will see your foot is off the gas and the throttle position
...sensor etc Don't replace the iac before you test everything. the TPS, MAP and O2 sensors as well as the coolant and manifold temp sensors have far more to do with your problem than does the IAC which ...
...iac motor 2. Crank Shaft sensor still the same Problem. P0505 - Idle Air Control System Malfunction The PCM attempts to control engine speed during KOER self-test. The test fails when the desired rpm ...
IAC) sensor/motor. This sensor is located on your vehicle's, throttle body. The purpose of this sensor is to control the car's idle under various operating conditions including ambient temperature. In
where is the iac valve located on my 1999 jeep grand cherokee 6 cyl or v8 Removal & Installation 3.7L The Idle Air Control (IAC) motor is located on the side of the throttle body. Disconnect ...
...iac not working If you have not done so pull the engine codes or have someone do it.The codes will give you a good idea where to start otherwise the first place I would check is replacing the ...
Question about 2004 Grand Cherokee Limited 4WD
...IAC sensor, cleaned throttle body, and added fuel injector cleaner. Not receiving any codes. Prior to replacing plugs, TPS, and IAC, received codes 0300, 0301, 0304, and 0204. Sounds like a vacuum ...
Question about 2006 Grand Cherokee
...IAC with a DMM...this will be in a chilton/Hanes guide. You can also spray MAF cleaner onto the MAF sensor within the MAF however, if the MAF goes out the car usually will not start. (Do Not spray ...
Question about 2006 Grand Cherokee
IAC valve ---ECM code p 2767 refers to transmission input shaft speed sensor/turbine shaft speed (TSS) sensor B---no signal===causes --wiring---transmission input shaft speed sensor /TSS sensor diesel
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions