Questions & Answers for: hydrostatic mower moves slow

...mower workes fine fore about 45 mintes then it slowes down wants to move real slow and wont pull my yard sweper anymore. The blades engage just fine, the motor starts/runs fine It just moves slow ...

...slow and still nothing. If you rock the tractor and move the speed control it will finally move again. Fluid level in hydrostatic is full. i have an AGS AJ102 I need to find a user manual please can ...

...hydrostatic relief valve will not allow the mower to move freely The wheels are adjusted too low causing the mower to cut the lawn very short. This will cause the blade to jam and eventually stall. ...

its moving very slow and not going up hills well if the engine is running well, sounds like your hydrostatic transmission is going out.

...mower gets slower and slower and then stops moving completely. I turn it off for five or ten minutes and it's okay ... occuring more frequently .... The hydrostat transmission is low on fluid. Check ...

...move. Had to push into the garage. Wondering if the belt could be the cause? i would suspect the hydrostatic transmission before the belt, however belt is much cheaper and you cannot make it worse ...

...moves slow forward, even slower in reverse My John Deere 2354hv moves slow in forward evenb slower in reverse this hydrostat drive tractor is designed to max at 5.5 mph forward, 2.5 in reverse, check ...

goes forward but moves slow If its a hydrostatic transmission your pump is bad.

...mower loses speed when under stress(hills). Also, strange noise coming from the front, I think. After changing the lower drive belt, and reassembling and testing. The tractor did respond to forward ...

...Hydrostatic transmission on my Lt150 mower is making a screeching noise when I push on the forward/reverse pedal. The mower will move very slow then stop. It is not the drive belt! Check trans. oil ...