resetting oil indicator I have recently purchased a 2005 saab 9-3 arc sedan. I changed the oil and don't know how to reset the oil indicator on the sid. if you still have the owners manual i would ...
...oil seal. It causes a glaze on the linings of the driven plate and loses friction. Or The clutch pedal is not returning to it's normal rest position when released. Check for objects trapped between ...
...Pedal after changing rear brake pads I just changed the rear pads on my SAAB. I never touched any hydraulic lines. The brakes work fine except for the pedal being softer than usual. It will go to ...
whaen car idles its fine but when driving it sputters an when it builds boost it blows the intake pipe off the throttle body an oil comes out of the throttle body in your car the air ventilation ...
failure of soft top .how to remove hydraulic hose from soft top. been told horror stroies about these saab hoods ,touch the motor manually and its a new motor for silly money .be careful and i do hope
oil warning light came on while driving home, then started flickering on / off for rest of journey 2mls. changed oil filter and oil used recomended Mobil 0 / 30. oil light went out on starting but ...
car started to run rough the oil light an the light by the top of the speedo came on at the same time stop the car immediatly , and check the engine oil level . I think that there is not enought ...
bad oil leak in 93 saab bad oil leak its spraying and everythingyhere is a puddel close to the oil filter but i dont no how it would be from it that bad there is oil on my hood Check the oil sender ...
Question about 2008 9-3
...hydraulic oil should be ok to use . Try to get the correct oil first but oil used in the power steering would be ok as it is a high pressure ,high temperature oil. If it is too thin then there are ...
Question about 2008 9-3
2006 9-3 2.0t conv. top won’t operate with switch. It did in March. Low hydraulic fluid due a leaky lift piston.
Usually answered in minutes!
175 Questions
14 Questions
