Questions & Answers for: husqvarna riding lawn mower engine

lawn mower stays running on jumper cables but once disconnected it shuts down when choke is engaged if it is already running and you "engage" the choke, you will flood the engine with too much gas and

...husqvarna riding mower that when i engage the blades the engine stops running Could be something jamming a blade or belt. With the engine OFF and the key OUT make sure the blades and belts all move ...

were is the battery at in a ct151 open the hood exposing the engine. it is right behind the engine almost under the dashboard. there is a rubber strap holding it down and two bolts holding the cables ...

tipped on it's side now will not start If you tipped it to the left the air filter will be soaked in engine oil and will need to be replaced. Also top up the engine oil to the correct level. You can ...

Battery is not getting charged, took the reading with multi meter and shows not increase in the voltage reading. Check the battery with battery tester and came out good. remove the upper cover from ...

made loud noise than just quit cutting grass than engine made a clunking noise and then stopped remove the cylinder head and rotate the engine over 

RUNS WHEN JUMPED BLADES WONT ENGAGE AFTER JUMPER CABLES REMOVED, ENGINE RUN ABOUT 30 SEC THEN CUTS OFF,SHOULDNT ENGINE RN ON MAGNETO POWER WHEN JUMPE EVEN WITH DEAD BATTERY? the coil can run with out ...

...riding mower 2013 Husqvarna LTH18538 and I ran over the garden hose how do I get it loose? Safety First! ENGINE OFF, WHEELS BLOCKED SO YOU DONT RUN YOUR SELF OVER, SPARK PLUGS DISCONNECTED, IGNITION ...

...mower deck to replace the drive belt. Make sure your brake is set as this relieves tension on the drivebelt system. Good luck. ...

will not start. First, remove fuel line from carb. Fuel should run out