Questions & Answers for: how to run toyota mark x system check

...Toyota rep. claims that their are no bateries in the sensors. OK. But from electronic experience how does that work? Any further input that you may have let me know as I can be reached at ...

...toyota 4 runner 3.0? 22r-E, 3vz-E And 3f-E Engines Warm up the engine, then turn it OFF. Connect a timing light to the engine following the manufacturer_s instructions. Connect a tachometer to both ...

...Toyota Camry turns over, but will not start, not even signal that it is firing/trying. I believe the spark plugs are accessed from the top of the valve covers (?) to check for spark. How do I check ...

...mark behind it....That will be on the camshaft cap....But you may be looking in the wrong place. Have a look at the map sensor, which is mounted onto the bulkhead firewall, about half way across the ...

...mark move with the timing light when you connect and disconnect the jumper wire.once you have everything hooked up loosen the dist. bolt and set the time to 10 degrees btdc at idle.tighten the dist. ...

...Toyota Camry LE sedan. It has approx 197,000 on it. I bought it used 9 years ago and I love this car It is in great condition. My question is I want to keep it in good shape and am not sure what ...

...toyota aygo my coolant tempterture warning light comes on when driving how do i get it fixed Your coolant is low !! stop driving ! it's not a complex thing to sort out. You need to top it up quickly. ...

...Toyota Vista Ardeo 1999 3S-FSE D4 All was OK until the tail gate was left open a little over a 2-3 days and the battery was drained dead flat. I charged the battery and installed back in the vehicle. ...

Toyota low coolant, air in the cooling system can cause the valve not to operate properly as I believe coolant has to run through valve for it to operate correctly. Fill/bleed air from cooling system.

...toyota pickup slight hesitation when starting out replaced rotor and cap, plugs, wires,fuel filter, brake master cyl. clutch, slave cyl., brake lines. Ran injector cleaner through system. Still jerky ...