Questions & Answers for: hot point water tank control

...point as I DID Not want to take the washer apart even though I am ver mechanical. Here is what I did to fix clogged/light off SmartDispense; 1. Put hot water in it. Sloshed it around, and removed as ...

...hot water, and the breaker is on I've worked on these before and most of the time it is the computer board which goes bad. I would check to make sure that my connections at the heater are good and ...

hot and cold water taps and remove back panel.  2. Loosen two screws that hold weight on back half and slide out weight.  3. Remove drive belt. Cut wire tie, unplug motor and leave

hot and cold water taps and remove back panel.  2. Loosen two screws that hold weight on back half and slide out weight.  3. Remove drive belt. Cut wire tie, unplug motor and leave

...water leaking from the bottom of the freezer. At 2:00 am the freezer had defrosted over three quarters of our food. Now we are not sure if we should replace it or repair it. PLease help. The side by ...

...hot; the hotter, the more it bends. This controls your iron's temperature. When it bends enough, it opens a set of "points", which are tiny cylindrical contacts at the bottom of the rotary switch ...

...Hot" or Max" and turn the motor off again. After repeating this process two or three times, the heater will probably put out a "little" heat, but not a lot. If the heater begins producing max heat, ...

...hot water,but every time we use the hot water it starts blinking. hitting the reset button does not help, it seems once the tank is full again it resets itself.What could be the problem? The evidence ...

...hot water boils to the point that it starts coming out of the pressure release valve because it gets so hot. My husband has replace the eco t stat, and tried re seating it twice to make sure it was ...

...point for a NO MINIMUM OPERATING PRESSURE. That is a function of the amount of water in the boiler. If the T&P is blowing off, it will vent water from the boiler and the boiler pressure will go ...