...Hot cold, I get cold water first, then hot water for the rinse. Any ideas as to what could be the problem. It sounds like you have the hot and cold water lines to the washer reversed. Try turning off ...
Question about Energy Star 44092 Front Load Washer
...hot water to the cold solenoid. or the wires have been interchange, the hot water wire was plug to the cold solenoid and the cold water wire was plug to the hot water solenoid. or hot water is still ...
Question about Ultimate Care II LSQ9549L Top Load Washer
...hot wash,cold rinse; cold wash, cold rinse;warm wash, warm rinse; and sensor cold wash, cold rinse. hot water is getting to the washer- have warm wash, warm rinse - but not hot when switched to hot - ...
...hot/cold now reversed Maytag performa washer hot and cold valves are hooked up correctly, but washer is giving hot water on cold setting and cold water on hot setting. Just happened suddenly after 1 ...
...cold? The hot is hot and cold is cold but warm is cold. There is too much pressure on the cold feed, reduce the pressure on the cold by partly closing off the tap on the cold. Or ensure the hot feed ...
...to the cold valve on the machine and the hot tap to the hot valve. on the machine it will have cold or c for the cold valve and hot or h for the hot valve. please reply if you need further
...hot and cold water hook up on a 71-40d which is which top and bottom Tanks are marked with Hot and Cold. 1) If water connections are on top of tank, look for red marking or word HOT that shows where ...
Question about Elite 45986 Front Load Washer
...hot/cold, warm/warm, etc.) If I connect hot water hose to cold inlet and cold water hose to cold inlet, the hot inlet valve opens but the cold valve doesn't open after pressing start. I get the FH ...
Question about AW22 Top Load Washer
...hot, half cold) and hot( which should be ALL hot water, no cold added at all!) but the hot setting has cold coming out too. Depending on the age of the unit you may be looking at a faulty switch. ...
...hot to cold & cold to hot) and try again. If you get COLD only, you probably have a bad COLD solenoid - if HOT only you have a bad HOT solenoid. If you get HOT only, you probably have a bad COLD ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions
