...If you have just the front and the rear outputs, hook those to the inputs front and rear. Then hook the output of the 4 channel to the input of the mono block. I hope this helped -Andrew ...
hook it up mono to one of my 15" subs. Looking how to wire it for mono. do I use the L - and R - or L + and R+ or something else. I have another amp that I will use for the other sub. I think that one
...mono amp for the subs. To hook them all up to the same amp you would need an amp with 5 channels. It wouldn't work out right. If you have a mono amp its only for subs. If you have a 2 channel you can ...
just hooked up mtx 500d mono amp and 12 inch sub Just hooked up mtx 500d mono amp and 12 inch sub worked for a 1/2 hour then sub quite and led on top of amp just flashes. either ur ohm load is way off
Question about 223xl Active Crossover (Stereo 2 Way Mono 3 Way XLR IO)
...hook up my loudspeakers to the high outputs one speaker plays only mids and the other only highs. How do I get them installed correctly? Hi, Seems that you hooked it up in the 3-way mono setting. ...
...them one input and one output the in put is mono if what your going to hook it to has rcas on it then the left one is a mono output but if its an audio system then it mit have a subwoofer output on ...
unsure what cable to use to hook system into amp. is jack on back of unit a stereo plug or mono plug ? Mono , they have adapters that will single out a stereo plug, But Mics are Mono mono
hook up a mono amp to my Infinity 475a 4 channel amp. It contains a rca output site on the Infinity to plug in the mono amp. Do I still need to have seperate ground, fuse and power cables for the mono
Question about MRD-M605 - V12 MONO AMP 600WX1 RMS 2 OHM Car Audio Amplifier
...hook up my v12 mono amp with my 12" type r car was already wired get good bass but if i put my stereo over 20 the amp kicks out ? mono v12 alpine amp and 12 " type r in ported type r box wondering if ...
...hook up 2 4 ohm speakers to equal a 2 ohm load? Most mono amps now a days give you multiple terminals. The older amps were a pain trying to stuff all the wires in one set of terminals. If the amp is ...
Usually answered in minutes!
980 Questions
644 Questions
497 Questions
317 Questions
274 Questions