...i tried just correcting the rcas i have a green light... but no bump from the subs... Plz help! Try hooking an mp3 player or some other source into the amp (in place of your car stereo)while the car ...
Question about 500/1 Car Audio Amplifier
...mono. you will probably be happier if you just hook the left speaker to left plus and minus and the right to right plus and minus. Cuz even though subs aren't directional they do pass some higher ...
...mono amp a when i turn up the volume i get a "pop" sound when it hits and it happend with a few diffrent subs so I was wondering if you could tell me how to make it stop. I had it hooked up to a 10w6 ...
Question about CVR12 Kicker 12" CompVR Series 2005 Car Subwoofer (800 Watts) Car Speaker
how do you hookup 2cvr 12 to a mono amp? Hook together both positives from each speaker together and both negatives from each speaker together and hook them up as one connection to your amp.
i hooked up my jl audio 500/1 and it turns on but there is no response from the subs. -Did you verify that you have an input signal? -Is the amp going into protection? -If they are bridged mono, are ...
I hooked up my two 10 inch JL Audio W3v2 2 ohms to a mono JL Audio 500.1 amp and the subs will not work. I have the subs wired in a series. I then hooked them up to my friends amp and the subs worked.
...hook 2 12" jl audio to a jl audio 1000/1 Is this sub an svc or a dvc? From what I looked up they are svc, so each sub's voicecoil is 3 OHMS, connecting them in parallel would lower them to 1.5, ...
...mono block that POUNDS my sub and doesnt bottom it out.. but when i hook up the JL i get to quarter volume and the sub starts to bottom out... i have plenty of voltage, im not over powering the sub, ...
...on the outside with just one wire. This is all assuming that you are hooking up only one sub. If you attempt to hook up 2 subs like this to a mono amp, you will drop the load to 1 ohm. hope this ...
Question about 12W3 Car Subwoofer
...hook it. I bridged it but amp has 2 chnl and 4 chnl stngs with rca jacks for both. whats the best way to set this up? if you have 1 sub u need a mono amp, two subs you can use a stereo amp ...
Usually answered in minutes!
196 Questions
131 Questions
85 Questions
67 Questions
48 Questions