Questions & Answers for: Behringer hook up mono

...terminal of the right channel and the positive terminal of the left channel. this is were u hooked up ur speaker. and thats is thats the bridge connection. u just mixed the L. & R. output ...

no sound to speakers We've just hooked up our PMP5000 and are not getting any sound from the speakers. We are getting a signal on the Mic channel and the LED lights on the Right are lit up. We've ...

...hook a subwoofer to this, which channel will control the volume of the sub? channel 1 or 2 ? [email protected] The sub out is in mono mode, so it takes the average of both channels and only let ...

...hook up my jbl-jrx112m monitors to my pmp6000 so i can control sound volume,i have sound but only main control not monitors You have to make a choice... you can tie two main speakers to the "B" ...

...hook up my passive mains and monitors in the mono1/mono mode....mains on B and Monitors on A outputs I don't seem to have much output volume on the mains.....my monitors are okay but main sliders are ...

...behringer xenyx 1204usb mixer with a mxl 990 mic and i have problems with static. thats all i have hooked to the mixer so i dont think its a conflict. i have tried recording in audition, pro tools, ...

...hook up the amp to the mixer into either mono's 1 and 2 or the main 2 however not in main 1 with full power.what r we doing wrong?the speakers are not run in series except for the b2520 to the ...

...HOOK UP PASSIVE MONITORS TO BEHRINGER PMP4000 If you are using the amp in stereo mode, then you will require a separate amp for the monitors and the input of that amp are taken using BALANCED TRS ...

how to hook amps to board Use an xlr cable to plug into out 8 ( the default mono out ) and plug that into your amp.