Questions & Answers for: hook cold water hot side

...cold water feed? Thanks Serena Munro Dishwashers normally are hot or cold feed. My wife runs water at the sink to get it hot going in before turning on the dishwasher. You can use either cold or hot ...

Do you hook up to cold water or hot water I'm installing a used 15872. Should I hook to hot or cold water? Hot water. they hooked the supply line to the wrong side,it should be on the hot side

...cold water only water enters the tub and exits out of the hot side of the water valve. Is the water valve bad? It seems unlikely that something went wrong just from moving it unless it got banged up! ...

...your at it hook a hose to the hot side connector and run it out side or to a sump pump then turn on the cold water and flush it out you can also reverse this procedure by doing it on the cold ...

...water on cold setting and cold water on hot setting. Just happened suddenly after 1 year of use. Noticed the cold water rinse was hot. Washer has not been moved. What's wrong? How do I fix it? Try ...

...also, this makes the cold water go to the bottom and push the hot out of its outlet,, how many faucets are involved, if just one might want to check the cartridge to make sure it is working ...

...700 i am hooked up to the hot water side. how hot can the water be before it ruins the distribution tray granuals? I believe it says I can hook up to cold or hot water. Hi max temp is 140f 60 ...

cold water hook up on a 71-40d which is which top and bottom Tanks are marked with Hot and Cold. 1) If water connections are on top of tank, look for red marking or word HOT that shows where hot water

...hook up both sides (cold and hot) to the cold water source? At this point it will not complete the cycle, just runs for a few minutes and must be encountering an error and shuts off. Yes both lines ...

...cold water comes out when turned to cold hot water comes out how to fix Who ever hooked the pipes up to the tap they put the cold pipe on the hot side of tap. Same the other side. You need to change ...