...hood from closing all the way. The most likely issue is the latch. Remove debris before lubricating and move the latch back and forth with your fingers to ensure it moves freely. Also inspect the ...
...hood latch will not pop the hood unless one person holds the latch up and the other puts their fingers under the hood to help it pop. cable broke off too Hello: Try lubricating the latch assembly ...
Question about 1992 Town Car
hood latch on my 1992 Lincoln Town Car Executive will not latch. I had to have the hood replaced and I now notice there is no bar in the hood for the latch to hook over. Use the latching assembly from
...hood latch assembly for a 93 chevy lumina The cable for the hood latch is diconnected from the latch assembly. I cannot open the hood. help! I know what the problem is. like my 93 chevry it came ...
hood latch cable on 1993 grand am is broken the wire cable for the hood latch is broken under the hood at the latch assembly. I can see where the cable comes from the latch inside the car. ...
...hood latch. I rear-ended someone and it pushed my front end in (up?) a little. The hood and grill have been fixed and nothing else seems to be out of place except for the hood latch assembly. When ...
...hood latch assembly, hood latch doesn't lock in place, all the the way down flush with bumper.where to adjust? Loosen the hood latch mounting bolts- you should then be able to move the latch assembly ...
Question about 1996 Grand Cherokee
...hood latch that does not work. The part of the latch that is operated from inside the car does not engage when I shut the hood. How can I fix this? have a 1996 Jeep Grand Cherokee with a hood latch ...
Question about 1996 Grand Cherokee
...hood latch. There is a hook like assembly that follows the hood latch down when closed. You can activate this assembly by hand. Be sure to release it before attempting to close the hood again. If it ...
Question about 1996 Grand Cherokee
hood won't close, it hits latch and safety latch only one holding it closed Use some wd40 and spray in the latch assembly,now get a screw driver and manually pull/pivot the hood release cable back,now
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
