Questions & Answers for: Chevrolet S 10 hood latch adjustment

how do you adjust door latchs I have to lift and slam drivers door to get it to latch properly I don't think the problem is the door latches. Sounds more likely that the hinge pins are gone. You say ...

...hood latch cable. There is a lot of interference under the hood. I have to take WD40 every 6 months or so and spray moving parts and have a helper inside pulling handle to get it moving again, may ...

...hood latch assembly. There will be a large gauge wire with a loop about the size of a large philips head screw-driver. This is the release. Take the screw-driver and push the wire towards the drivers ...

...latch on my 1999 chevy s-10 is broke how can i open the hood can u see the black cable housing if so just skin some of the cable housing back be carefull not to cut cableafter u get it cut just use ...

hood latch cable S-10 chevrolet 2000 can not open hood The best way to gain access is to remove the grille. Look in the holes of the grille and you'll see screws that hold the grille in place. Unscrew

...hood release not easy. depending on where it is broken, if its broken at the handle, you can try a pair of vice grips on the cable where the handle would go on. if its broken further down, you can ...

...hood while latch pulled but will not work. What now, read remove grill but looked at instructions, said open hood take out four screws under hood. look at the cable sounds like when you pull the ...

Hood release on my 2000 S10 extreme is very loose & won't open hood! How do I open hood from grill? They did it at the garage once before & adjusted it but it has loosened up again Get ...

...hood latch where the cable end attaches to the lever was broken.I finally drove a 3/4" mop handle and by prying,forced the grill down enough to unbolt the hood latch and after messing with it for a ...

hood latch problems hood will not latch. tried to adjust latch; but to no avail. still will not latch. what should I do? . you can purchase a new latch on ebay for about 20 to 25 dollars and replace ...