Questions & Answers for: Chevrolet Corvette hood latch adjustment

hood latch cable on my 1972 corvette broke. How can i open the hood? Remove the honey comb grill from the drivers side and you can reach in and release the hood Remove the grill work from the front of

...hood latch 1985 corvette When I pull the hood latch only the passenger side of the hood is released. I can't get the other side to release. I can't get my hood open to check oil or anything else. Is ...

Hood latch stuck 89 vette can not get hood up. Is Hood latch stuck 89 vette can not get hood up. Is there a bypass? there is no bypass have someone pull up on hood while pulling release or u can ...

...when hood latch inside car is pulled. 89 vette hi there latch inside the car is connected by a cable to the lever that pops the hood, it seems to be broken.ill suggest you see a mechanic kind ...

...release Hood latch on passenger side needs adjusting, Have someone put pressure on side of hood when you are pushing the hood latch release. This may help them when they are pulling up on the

hood latch wont open You will need to reach under the top of your hood to see if you can locate the release cable. There should be one on either side of the hood. If you can reach the cable and manage

...a little bit then I located the latch and opened the hood all the way up, then generously sprayed lube on the rusted latch and coil. Once a month I will lube this area to prevent this in the

on both sides and adjust your hood. Another thing is too roll over a bumpy surface while working the hood lever.If all this fails ecklers corvette sells a hood latch lever to reach the release springs

...the pass side wont release any suggestions My 81 did that, cable has needs replaced under the hood. To open lift up hood on drivers side, slide hand under hood and pull cable where it hooks to

hood latch broke and I need to open hood to fix this I hope this will help. I own a 1999 Buick Regal GS and had a simular problem. What I did was lay on the ground and simply reach up and manually ...