Question about 1983 GL 1100 Innerstate Gold Wing
apparently the valves on a 83 1100 wing need adjustment every 10,000 kms, how do i do this? thank you The correct valve tappet clearance is .004" on both the intake and exhaust valves (cold engine). ...
Question about 1981 GL 1100 Innerstate Gold Wing
I have an 1981 honda goldwing and on both sides of the crankcase there are bolts and they both are leaking oil at the bolts i tryed to tighten them but don't wan't to bust the bolts off it still leaks
...Honda Goldwing and the mechanical valve lifters and rocker arms make a ticking noise after the oil warms up.I have set the valves to specs and have set them a couple of thousands tighter and either ...
...timing belt? Is this a job for a home mechanic? I think Honda recommends 40,000 miles though your probably OK up to 60,000 miles. When in doubt (and for peace of mind) just replace them so you do not ...
Question about 1983 GL 1100 Innerstate Gold Wing
...timing marks. To line up the 1 T F mark you will have to rotate the motor. This is done by removing the tappet cover in the center of the magneto on the back left corner of the motor . To rotate the ...
...timing marks. To line up the 1 T F mark you will have to rotate the motor. This is done by removing the tappet cover in the center of the magneto on the back left corner of the motor . To rotate the ...
...marks 1981goldwing 1100 Google Search GL1100 Timing mark with timing light Honda GoldWing GL1100 Service Manual http://www.partsfish.com/page/oem-parts-for-honda Honda Gold Wing GL1100 Owner ...
Usually answered in minutes!
114 Questions
68 Questions
31 Questions