Questions & Answers for: honda 5hp

...5hp Honda gasoline engine, 2300 psi delivery. Upcomer is small diameter (3/16" or 1/4") clear flexible plastic tubing connected to hose barb on pump head (downstream). Ball check and spring inside ...

Ad

...5hp honda stationary engine i had to put a car modell to get through. The IAC, (Intake Air Control valve) is a rotary valve that binds with carbon build up. the valve is usually on the bottom of the ...

Ad

Question about Water Pump Honda Engine

1 Answer

honda 5hp cold pressure washer , i have no other details on this washer doubt very much if the unit is produced by honda themselves ,but rather sone else has produced it ,and used a honda motor.i have

Question about Water Pump Honda Engine

1 Answer

...honda 5hp 4 stroke engine on a generator wont run with air filter on runs perfect without can you help Check to make sure the filter isn't plugged. If it is good, look below the filter and see if it ...

my honda pressure washer gl160 5hp cranks fine but will cut off after a minute or so. It will cutoff even if not under pressure, so its something to do with engine check the oil level in the engine.

Question about Pressure Washer PSI 3000

1 Answer

Honda 5HP pressure washer. When you press handle to get pressured water, motor does not rev up to give you high pressure. Most small pressure washers do not have an automatic throttle control to ...

Question about Maxus Pressure Washer MX5222

1 Answer

Hello- what is the oil capacity of a Honda power washer Model XR2600 (2600 PSI) 5HP manufactured in July 2004. Thank you. oil capacity is 20 oz. 10w-30

the spark plug is missing on my XR2600 Pressure washer. What NGK spark plug can be used to replace it? ngk bpr6es

Question about Gx140 5hp Engine

1 Answer

governor pivot shaft leaking oil leaking oil around pivot shaft on Honda gx140 on a Honda hs55 snowblower over filled or bad seal. or someone tilted over engine, 90 degrees. or more.

...the coil on my Honda G300 5hp rotavator. Because there isn't a spark on the plug 1042675 is stamped on crank case pull out all coils. use an ohm meter to check ohms on all and see if they are ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Honda Garden Experts

Sean Wright
Sean Wright

Level 3 Expert

2045 Answers

john h

Level 3 Expert

29494 Answers

Jesse Walters
Jesse Walters

Level 2 Expert

337 Answers

Are you a Honda Garden Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...