Questions & Answers for: holding tank wiring

tank as well as the wiring harness 4 unhook the fill tank hose 5 lower the tank to the floor 6 remove the O ring that holds the pump in the tank 7 pull the old fuel pump out and put the new one in the

...tank holding tank to frame.Disconnect fuel lines and any wiring or sensors connected to tank Remove bolt and pull tank up and back to clear 2 rubber nubbers on the front side( Eachside has 1) Don't ...

...holding on the two belts, place a jack under tank (protect tank with wood or other material), undo two belt bolts towards the rear of the car and then slowly lower the tanks. this should get you ...

...holding the tank on, or it it just slides forward. I believe there is one bolt under the seat at the back edge of the tank. You will also have to disconnect the fuel lines. Put the tank switch in the ...

...HOLDING THE TANK, BEFORE YOU COMPLETLY BRING IT DOWN CHECK AND REMOVE ANY HOSES OR WIRES ATTACHED TO THE TOP OF THE TANK. (BE CARFULL NOT TO PULL THE TANK DOWN TO QUICK OR HARD BEFORE REMOVING WIRES ...

...holding the tank on *Remove the 3 screws holding the speedometer on, left the speedo and unplug the wiring harness *Disconnect the fuel line on the left side of the tank *Lift the tank and unplud the ...

...tank. it should have a wiring harness that has a blue retaining clip into it that keeps the fuel pump plugged up. there are 2 bolts that hold the straps that hold the tank up. the more fuel in the ...

...tank you have to hold the tank up and remove the two bolts normaly a 14mm holding the strapped to your undercarriage then remove the filler neck and evap hoses and wiring harness then lower your ...

...holding the tank in place then lower your floor jack (which should have never been removed) slowly take out the fuel pump carefully so nothing breaks off and stays in the fuel tank and replace ...

So, how do you correct the disconnected ground wire from the fuel tank to the chassis? Do I need to get an auto electrician to fix this problem? no, there is a seam round the sides on metal tanks put ...