Questions & Answers for: Mazda hoist

...2.5v6 1993, do you have to remove the engine? It's easier to remove the engine but if you have a hoist and good gears you might get away without removeing the whole

...on that side and lift the motor up about 3 ". I worked at a garage so I had access to an engine hoist. Try using a jack from underneath. Nice engineering from Mazda!!! photo copy the instructions ...

...UP ANY SUGGESTION WELCOME sounds like a timing isue have them do a sensor test start the car on a hoist then tap the engine or if posable tap the timing sensor and also try shaking the wires

...If you are unsure what you are looking at or for take it too a shop and have them put it on a hoist and check underneath. It will be well worth the cost if it saves you from replacing your ...

...for 2006 mazda tribute The ABS light stays on in my 2006 mazda tribute, canadian tire put on hoist and showed that there is a compressed part looon the front end axle that is now separated

...room for a jack of some kind and your self in order to remove the tank. This is best done on a hoist. Should you need further help please just ask. Please rate the answer you received. This way

...mazda protege 4 cylinder you need to clean the engine off and fill it with oil,put your car on a hoist to find the oil leak when it starts so it doesn't run to other places and you think its ...

how to replace a starter on mazda6 wagon Disconnect +ve battery cable, BEWARE you will lose the stereo functions unless you have the security code. Place car on hoist / ramps unbolt/ remove from car.

mazda pickup 1993 B2200 removal of oil pan can't get oil pan out. You'll need a engine hoist to remove the oil pan of a 2002 Cummins. You need to lift the engine just enough to get the pan to ...

...and turning the steering wheel 90 degrees right and left it makes a clunking noise. Put up on a hoist and doing the same it makes no noise. What is it. the noise is generated by the weight on the ...