I have a clunk noise in front end pasenger side when I drive over bumps in road. Had car on hoist and all is solid, I do not want to play a guess game as it will be costly,, anyone else have this ...
1998 town and country trying to change spark plugs in back You need a hoist. Even with a hoist I could not get out the passenger side plug in the back. If you try you need swivels and several LONG ...
...transmission fluid on my 02 sebring 4cyl, 137,000 miles, just bought the car have u put it on a hoist top up fluid run it to see if it is the rad tank/cooler or return lines or seal of some ...
Check the lines to the Trans Cooler in the radiator at the radiator. you need to have your van on a hoist to see where the leak is coming from
remove power steering pump 1997 Town & Country, 3.8L 2 wheel drive, w/A.C. you might really want to let this job to a good shop with a hoist.
...and vote Thank You and Good Luck Release hood latch and open hood. Remove the headlamp assemblies. Hoist vehicle and support with safety stands. Remove the five push pin fasteners attaching bottom
...chrysler 3.2L & 3.5L EnginesDisconnect negative cable Drain cooling system. Raise vehicle on hoist. Disconnect electrical connectors from engine oil and power steering pressure switches. ...
is it hard to replace a fuel pump in a 2002 chrysler sebring It's in the fuel tank, so without a hoist, it's a bear. I'm not saying it can't be done, but without experience, proper jacking and ...
DTC P0452 Where is the NVLD assembly located on the Chrysler 300M? Under your car. It is by the gas tank and the charcoal canister. Probably need a hoist to replace it.
Question about 2006 300
be worn wheel bearings or worn brake pads / loose shims. Take to a garage. They will get it up on a hoist and check
Usually answered in minutes!
1,229 Questions
1,289 Questions
1,198 Questions
1,079 Questions
1,173 Questions