...Hitachi UltraVision TV is turn on, the Power, Temp and Lamp lights will turn ON, blink a few seconds and then Power and Temp lights will go OFF. No picture and No Sound..blank screen. Any
...hitachi projector Hi m8s My projetor is up and down 25cm from the roof I put the new lamp and the airfilter and when i start it It starts lik 2-3 minutes and it shot down...and the power light is red ...
hitachi projector temp light upon powering up the projector the the temp light comes on and projector shuts off while temp light is flashing This is what your projector's user manual says about a ...
Question about 50V500 50 in. HD-Ready LCD Television
Hitachi 50V500A will not turn on.Power temp lamp strobes .Hissin Temp light remains flashing. Blinking temp light means bad lamp fan. Needs replacement It doesn't say so in the manual, and Hitachi
HITACHI 50VS810 WON'T TURN ON. . TEMP LIGHT KEEPS FLASHING If the set comes on momentarily, see if the lamp fan is turning. If not , the fan is probably bad. Hope this helps, skyassoc
Hitachi 50V500 cooling fan is noisy (elec. vibration noise). Have no Temp light. Replace the cooling fan so that the thermal switch for the temperature light goes on.
Question about 50VS810 50" Rear Projection HDTV
Hitachi 50vs810 has a blinking temp light. I already pulled the lamp fan and verified that it is running. I also ohmed across the temp sensor for the light and it is open. I'm not 100% sure if that is
Hitachi model number 50V720 does not show picture or sound when turned on. The Temp light and the lamp light flash red on and off. What's the problem? Check the tv fan it is running?No than the fan ...
Question about 50V710 50" Rear Projection HDTV-Ready Television
temp light is blinking, that indicates that one (or more) of the cooling fan has stopped spinning. The TV will stay off to protect itself from overheating until the fan is replaced. There are two fans
Question about 50VF820 Projection TV
Hitachi 50vf820 tv and it comes on for a second then cuts out and blinks red temp light. Does it need to be reset of something. After replacing the whole lamp assembly it only works for a second, goes
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions