high beam relays in the fusebox and there was no change...no low, high OK. I can feel the low beam relay click when turning on the low beams and then the high beam relay click when turning on the high
...High Beam work fine and diriving lights work as well. hi from uk provided you have checked bulbs are ok? then this fault may be the relay for the low /dipped beam has gone faulty if you check h/book ...
...one for your high beams. check for that and then if high beams are working swap it with low beam relay. if your problem switches to low beams working and high beams not working replace the bad
high beam position. If the headlamps stay off, try plugging the high beam relay into the low beam position. If the low beams now come on, the relay is shorted. If none of this works, I would recommend
Question about 1998 Explorer
...is a low and high beam relay controlled by the dimmer switch.If the low beams work and the high beams don't, and the bulbs are good, check the dimmer switch and the high beam
Question about 2005 Camry LE
...high beam circuit. There is usually one fuse for the left and one for the right high beam. 2. If the fuses are OK, check the Relay (also normally found in the Fuse and Relay boxes ) for the high beam ...
Question about 2010 Impala
...High Beam Headlamp Operation Battery voltage is applied at all times to the coil and switch sides of the HIGH BEAM PCB Relay located in the underhood fuse block. When the headlamp dimmer switch is ...
Question about 2010 Impala
...high beam relay in the underhood fuse block. When low beam headlamps are requested, the body control module (BCM) supplies ground to the coil side of the low beam relay. This activates the relay and ...
Question about 2010 Impala
...high beam relay in the underhood fuse block. When low beam headlamps are requested, the body control module (BCM) supplies ground to the coil side of the low beam relay. This activates the relay and ...
high beam relay has stuck contacts inside . Headlamps The headlamps may be turned ON 2 different ways. First, when the driver places the headlamp switch in the HEADLAMP position, for normal operation.
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions