Questions & Answers for: hi scan pro Cars & Trucks

...Hi-Scan Pro to the vehicle data link connector located underneath the dash panel. 2.Turn the ignition key to the "ON" position and turn on the Hi-Scan Pro . 3.Check for diagnostic trouble codes. 4.If ...

...Hi-Scan Pro (with Hi-Scan SOL Pro Software Version 09-29-03 or newer) and Data Link Connector (DLC) Cable.SERVICE INFORMATION: The keyless adapter cable can be used on the following vehicles: 2001 - ...

...Hi-Scan Pro Section), the DM-TL activates to check for system leakage. The air pump and shuttle valve work on the command of the ECM. Motorized Air Pump - the pump pressurizes the evaporative ...

...are on. The car is a Hyundai Santa Fe. IT IS POSSIBLE THAT THE BRAKELIGHT SWITCH IS FAULTY AT THE PEDDLE BEST IS TO PLUG IN A HI SCAN PRO TO GET FAULT CODES THIS SWITCH IS THE BRAIN OF THE BRAKE ...

Hi-Scan Pro and check for Diagnostic Trouble Codes (DTC) in both the "ENGINE" and "AUTOMATIC TRANSAXLE" menus. If the DTC shown are found, follow the repair procedure shown. If no DTC are found, go to

Hi-Scan Pro (with Hi-Scan SOL Pro Software Version 09-29-03 or newer) and Data Link Connector (DLC) Cable. SERVICE INFORMATION: The keyless adapter cable can be used on the following vehicles: ^ 2001

...Hi-Scan Pro in the Hyundai Diagnostic Menus Current Data Screen TPS (%) 0 3.5 5.1 7.4 MAF (kg/h) 10 21 30 47 RPM IDLE 2000 3000 4000 Table 2: Using the Hi-Scan Pro in the OBD-II Menus Current Data ...

Hi I got a 03 merc c200 kompressor - the light is on the dash - engine light but the guy said its from **** fuel and u just need to reset it at any Mechenic n and commodores Mechenic can just plug int

...hi-scan (pro) to the data link connector located underneath the dash panel. Select and operate according to the instructions on the hi-scan (Pro) screen. CAUTION You must obey the maximum operating ...

...says pro scan but wont continue to tern on so i can use it whats wrong hrere Hi, turn EVERYTHING off...... leave it for a good 5 to 10 minutes, then reboot it all up again. it may just need a ...