Questions & Answers for: Ford F-250 hello bolt

...is frustrating me, and I'm lost with the troubleshooting right now. Can anybody give me a hand??!! Hello, If your low beams work it's not the multi-function switch located on your steering column ...

...hello krowley yes, one of the control doors have gone bad. The easiest way to get to it is by removing the panels in the passenger area. They can be removed by reaching underneath and unscrewing the ...

hello I trying to make my 2000 f350 single wheel in to a dually.like to know if I can bolt the dually wheels right on and do they make a kit for the front end Heiio, the answer to your question is you

...bolt pattern in 1999. Thanks. Hello, Sorry the 1989 F250 4wd wheels are not interchangeable with the 2000 F250 4WD.. The hubs where changed to a new design and (Bolt Pattern: 8 x 170MM) From 1999 to ...

Hello, The Pickup transmission has developed a severe leak of fluid.It will leak continually, whether the truck is running or just sitting.If left parked the transmission oil will leak from above ...

meaning of red battery light on dash Hello Mdeon. The red light is indicating that the alternator is not correctly charging or not charging at all. Basic check would be to verify that the drive belt ...

Hello...I have a 1990 Ford F-250 with 70,000 orginial miles...it has the 300 6 with a auto trans...it has a knock when I put it in gear...my mech said it was a bad wrist pin...come on...the 300 6 is ...

...460 stick shift where is the fuel pump located at? how do i get it out and replace the fuel pump? Hello, The fuel pump should be on the front lower block on the Drivers side. Sometimes it is easier ...

...Hello, I had this problem on my 2600i Mazda. Check your clutch resevoir--if this is low or empty this is the problem--there is a leak. The leak is usually the clutch cylinder (has a bleeder valve) ...

...Hello, I had a similar problem with my Econoline--the vehicle would not start because the vehicle would not go in park (I had to manually move the linkage arm). For my problem the linkage bolt had ...