desiel to gas What type of parts are needed to swap out a 6.5 desiel to a 5.7 gas or will every thing bolt up ? The engine will bolt up with little trouble, however the rest will be a problem. ...
No clutch after changing starter. Yeah. The piece had a line to it. I didn't want to remove it, but there was no way to drop the starter without doing this. It had two bolts holding it in, and held in
4L80E Diesel Transmission Replacement I have a 99 3500HD Chev Van diesel - 4l80E Trans is bad -- Do I have to replace with a tranny from a diesel or will a tranny from a gasoline 4L80E work? the gas ...
How do you replace the fuel pump on a 1976 chevy 3/4 ton pick up? I believe it is located on the passenger side on the bottom of the engine block Remove gas cap, pull the two fuel lines off the fuel ...
i have a 6.5 turbo deisel that i am replacing the turbo on =. what kind/bolts are needed that connects the turbo base to the manifold? regular grade five bolts are fine. You will probably never have ...
I have a 1998 Chevy truck 7.4 . Starts great cold after it runs and you leave it set for 10 minutes it starts hard. bad starter selinoid, to much heat coming from exhaust manifold right down on ...
what is the torque spec for a 1989 chevrolet 454 intake bolts. Hello there the tourque specs are as follows . Intake manifold bolts (cast iron head) 25 - 30 ft.-lbs. ...
I have a1996 chevy c3500hd truck w/454 engine all bolts are off oil pan, can not remove oil pan, clearance problem. Help Don You could try this. It works on the previous generation Chevy trucks but I&
98 chevy 350 5.7L how to change the carburetor it is not a carburetor, it is a throttle body-disconnect the harness, the throttle cable and the bolts that hold it onto the intake-after you have ...
how to align doors with welded on hinges 1988 chevrolet truck use a cherry picker or find some way to suspend the door in the open position so bolts can be put in the body..
Usually answered in minutes!
71 Questions
46 Questions
31 Questions
35 Questions
34 Questions