Questions & Answers for: Nissan hello bolt

...each bolt again 90 degrees Hello is this the same thing for 1999 nissan Sentra What is the head bolt torque settings for a 160gxi 16v Google the question and the answer will be there in a

what are the torque specs for transmission pan bolts on 2003 maxima hello! the torque specs on transmission oil pan are 62 to 80 inch pounds or 7 to 9 newton meters. hope this information helps you!

Need to replace the front drivers seat in a 1990 Nissan Skyline Hello Peoples I Need to replace the front drivers and passangers seats cant someone pleas tell me how to remove and replace please the ...

serpentine belt replacement Hello! I've attached the routing diagram below - please note that you will need to loosen the bolt(s) for the tensioner. Thanks for using FixYa!

...hELLO remove your transmission from your truck and unplug all lines and electric wire from it and you will see your pusher plate removed all bolts on the pusher plate and remove the plate and the ...

...hello, dipstick is on left of motor when looking from front towards the fire wall, has a 10mm bolt, remove bolt and hang on to it, if vehicle has been driven, start her back up, pull dipstick, wipe ...

how do i remove bottom part of seat to fit seat cover Hello, Use a flashlight to look under the seat for a series of large bolts fastening the seat to the frame. Remove these bolts and the seats ...

Hello, Where is the Cam position sensor located on a 2004 Nissan maxima bank 1 located? 3.5litre V6 Front wheel drive, the cam position sensor is in the back of the cylinder head above the ...

...bolt torque sequence for 2002 nissan altima 2.5s engine procedures to change the head gasket hello I have 2007altima 2.5s will replace the gasket I just want to know what is the torque for mounting ...

Hello I’ve just brought some genuine Nissan xtrail Crome side steps the brackets are a bit loose do to rust how do I go about replacing new bolts Hi. If the old bolts are visibly good but rusty you ...