Questions & Answers for: General Electric heater plate Water Heaters

...heater? How will I know when it's heating up or back on?' it usaly takes a few hours to heat up depending on water size check our breaker to see if it tripped out make sure all your wire connections ...

...around the bottom of the burner and the base of the heater it is cloth take it off and clean it , also there is a plate inside the unit that you would have to take the burner assembly out to clean ...

plate to see if there was in water at the bottom of the tank. I did not see any water. This morning I tested the heater by running the system on the hottest setting. I observed a small amount of water

...about the size of a large dinner plate and it seems to be coming from a leg hole. did you check your pressure relief valve,usually on the top of the heater,it has a spring activiated handle on ...

I'm getting hot water for 2 minutes , then it gets cold Most electric hot water heaters have two thermostats, one near the top of the tank and one near the bottom, and are covered by removable metal ...

...heater from propane to natural gas? First thing to do on any gas job is check the fitting line for leaks. If the piping you are connecting to is "gas tight" then your good to go. Usually on the ...

...heater - last night we set a new jug of detergent on top of it over the electric plate on the top of the unit - it had a hole ( small leak) in the bottom - it leaked all night slowly into the little ...