Questions & Answers for: Kenmore heater plate Washing Machines

plate has to be dropped, the control panel will have to be dropped, 10 or so screws across the very top of unit must be removed. th ebeltis the removed and the drum is removed from machine,(lifted off

...the freezer. Please give me some advice, the model # is 203c2181p003, part #sr1087 defrost system not working. take back plate off freezer. checkdefrost heater and any stats mounted on the ...

...plate grill and turn the timer slowly clockwise until refrigerator compressor stops running. Leave it there for about 30 minutes or until refrigerator restarts. During this time the refrigerator ...

...heater is bad it's a good idea to change out the t stat anyway,if it has an adaptive defrost board check the tech sheet that should be behind or on the bottom kick plate,remove it and look it will ...

...own boss. Give it 25 degrees F in the ice mold, a good ice mold thermostat, a good heater, a good motor and a clean plate and that baby will flat throw out some ice for ya. Manual and more wisdom ...

...plate off of the machine, where you can see the heater box. a new one can be purchased at a heating and supply jobber that sells replacement parts for appliances. as a stop gap measure you can find ...

...heater or timer. If you pull off your toe kick plate you should be able to locate the timer. On the side of the timer, should be a shaft which can be turned one direction only. turn slowly until you ...

...heater and the resulting surge moves the ice on around at an astounding snail pace not unlike watching grass grow. At near the end the water valve gets energized by a probe rubbing against a copper ...

...plate. I can't think of anything that would make the microwave oven do that, UNLESS it's a microwave/convection oven, in which case, the convection heater must be coming on whenever you are trying to ...

...plate to inspect, see below diagram: Unplug the wire harnesses of both relays and plug the heater wires into the motor, motor wires into the heater. If the dryer stays running when you push "start", ...