Questions & Answers for: Teledyne Laars heater plate Heating & Cooling

...for Teledyne Laars Mark V All heaters have a data plate. Often the model # is the BTU's. For example, H400 is a 400,000 BTU output. The plate is on the inner firewall. All heater have different

...heater down. On the rear of the water manifold block their is a eye shaped piece held in with two bolts. Remove these bolts and the plate comes off and will have a brass or steel rod coming from it ...

...down the right side of the heater. Inside the ignition control will have one screw that holds the mounting plate in place then it will swing out on hinges and all your wireing will be done behind

plate the terminal itself is on and the ignitor assembly. If the signal from the probe that registers the heater is operational cannot get back to the ignition control module the heater will behave as

...heater, or on the backside of the door. This will mention model information as well as BTU ratings. If this identification plate is worn, or burnt, just take a picture of it and send it to ...