Questions & Answers for: Reddy heater plate Heating & Cooling

...many watts is this heater going to pull so i don't damage the inverter? Look at the plate on the side and calculate Voltage (110 typically) times amps (what ever it says on the plate) gives you

...WHEN IT KICKS OFF THE FAN IS STILL RUNNING replace the nozzle and check the fuel filter - if this is a kerosene heater. under the access plate is a round filter - remove it completely or change

plate off by the air adjustment that has 4-5/16" bolts. Start the heater and see if you have air coming out the vent hole on the left side under the top bolt. [A] If you do the air pressure gage needs

...heater. Is there a fuse somewhere? no fuse per se, but mounted on the round plate where the burner nozzle is and slightly to the upper right is an overload device with two red or white wires coming ...

...heater had no manual understand co. is bankrupt 12/29/2008 please help me find one rickzilla. thank you The manuafactures website is still up. If you have the model # (should be located on the rating ...

Heater won't fire up. It worked fine 2 days ago. Can I adjust the screws in back to make it start. there is only one adjuster screw in the back of the unit.most likely your problem is in the rotor.you

...heater r100a blows fuel but will not ignite if i lift one side of top chamber cover it will fire up the air pressure is not set correctly.take a look at the back plate very closly and check to see if ...

...heater. Change filters and spark plug. Not fueling.R Clean the injector located right beside the spark plug and check both rubber tubes that connect to the housing that the injector screws into and ...

The required pressure should be listed on the data plate of the heater. If you can't get the air pressure right, your air filter could be the problem. Let me know what you find if this doesn't fix it

heater 115000 btu fan spins freely until I put the plate on the back of the motor back on. It then instantly tightens the fan so it won't spin. The black circle on the back of the motor is what causes