Questions & Answers for: Blue Flame heater plate

...heater. Five times I have used compressed air (as advised by manf.) and a clean tooth brush to clean the three ceramic plates but only two will ignite and glow, the third will stay unlit. I can watch ...

Can I convert and Vanguard VP11A LP gas heater to NG That heater was not designed to be safely converted to Natural Gas. Even if you could convert it, it would cost more to do that than to replace the

...until room is about 65-70 derees and then shuts of killing the flame and pilot, I can restart the heater but it will shut off after about 5-10 minutes. Does it have an oxygen sensor? Might have low ...

...a thermocouple at one end of the burner. Pull it back away from the burner toward the front of the heater slightly.This will allow the heater to operate at higher temps without shutting off the gas ...

I have a charmglow natural gas heater model CGN300TB can I convert this to propane gas? yes just contact your local gas dealer for the right fitting

I have a DESA propane vent free heater; model CBT30PT (4 yrs old). The heater was cleaned and worked fine until this year. The pilot lights and the heater functions for about 15 - 2o min. then the ...

...shutting off after a minute??? Not too familiar with this product, but it looks like a vent free heater.  ALL vent free heaters are required to have an ODS pilot light.  These pilots ...

Just installed a 30,000 btu Mr Heater blue flame heater last night, worked perfectly. This morning the flames and pilot light are burning mostly orange. What could be causing this. That is a bad ...

Pilot light blows out while heater gets hot. Mr Heater 30000 butu ventless propane wall heater. Nice blue flame to start with, but starts blowing away from the pilot orifice as unit gets hot. call a ...

I have a blue flame heater 10,00 BTU, I light it and it seems OK for about 5-10 minutes then it goes out pilot and all. I put my other heater next to it and it runs just fine.They share the same line ...