Question about StreetPilot C330 GPS Receiver
...heat shrink but the battery became too thick for the metal bracket to fit around it. I cut off the heat shrink and wrapped the battery with electrical tape. Much better fit. Tip: after removing the 4 ...
...heat shrink or cover the solder joints), put in the new battery and you are done the easy bit. You will most likely have to trim away some of the plastic on the holder such as legs or other things ...
heat shrink tube the battery is in and de-solder the joint. Solder new battery. A small 15W soldering iron will do the job perfectly. Make sure not to overheat the battery. Insulate the solder joints.
Question about GPSMAP 178C Sounder GPS Receiver
...place a piece shrink wrap on before you solder it back and then make the shrink wrap flush with the back of the plug and heat her up. And, Voila... no more intermittent operation. Hope this helps? ...
Question about GPSMAP 178C Sounder GPS Receiver
...heat shrink tubing. If you experience difficulty wiring the unit, please contact an installation professional in your area. Make sure the connections are good on the rear of the unit including plugs ...
Usually answered in minutes!
1,343 Questions
1,187 Questions
1,096 Questions
889 Questions
690 Questions