Questions & Answers for: Buick heat shrink

heat shrink tubing, and the "bullet-style" solderless connectors. 3. Take the 16 ga. wire and cut into 2 four-inch pieces. 4. Strip off approx 1/16" of insulation off each side of both wire pieces. 5.

...between the plug and the frame and replace with good speaker wire. use crimp connectors and heat shrink or silicone to seal your joints and recover with the plastic shield. Hope this helps, ...

wiring harness at the flex point. Peal back the outer casing to expose the wires & repair any broken or frayed wires. You can solder & tape or use heat shrink if you have a heat gun. Good luck

...are it is kinda melted Replace the light socket. you can get them at your auto parts store. Get some heat shrink tube at the same time. It seals better than tape on the joints. Hope this

...antenna, side marker lights CHECK YOUR WIRES IN TRUNK THAT RUN ACCROSS FROM LIGHT TO LIGHT BUICK IS KNOWN FOR THIS AS ONE OF THE HOT LINES HAS WORN A BAR SPOT YOU CAN BLACK TAKE IT OR HEAT SHRINK

...shrink and dry out over time and the harsh environment under the hood makes it worse. Check all vacuum lines and fittings attached to the intake manifold, valve covers (pcv valve), and be sure to ...

...shrink and dry out over time and the harsh environment under the hood makes it worse. Check all vacuum lines and fittings attached to the intake manifold, valve covers (pcv valve), and be sure to ...

...a new switch if the connector is heat damaged the new switch will burn out very quickly. Also do not use crimp connectors to install the repair wiring connector, solder it and use heat shrink

heat shrink tubing over the wire,add wire, any colorbut the same wire size or gauge & solder them & then heat shrinkIf only the plastic is chewed & no copper wire ,then seal with clearnail

...heat shrink tubing first I took the old connector in hand and I see the pin numbers clear as day.. 'but of destroyed,(a key word) I get the colors off the SM my car I have my real service manual and ...