Questions & Answers for: heat shrink

Ad

Question about Satellite Radio Receiver

1 Answer

heat shrink tubing. Small heat gun. Small pliers, cutter, and Xacto knife. 1) The first step is to use the Xacto knife to cut both ends of the antenna cable so you have a clean end. 2) Using the Xacto

Ad

Question about Satellite Radio Receiver

1 Answer

heat shrink tubing. Small heat gun. Small pliers, cutter, and Xacto knife. 1) The first step is to use the Xacto knife to cut both ends of the antenna cable so you have a clean end. 2) Using the Xacto

Ad

Question about Satellite Radio Receiver

2 Answers

heat-shrink. I would recommend very carefully use a knife to remove the isulation from each end of the chewed wire and very carefully strip enough insulation off the wires that you can get a heat sink

Question about Satellite Radio Receiver

1 Answer

heat shrink marine connecters Strip you wire, push the ends into the connector and crimp the connector with a special crimping tool designed for the connector. Heat the shrink sleeving with a heat gun

...on the other end. Or cut wires, solder, and use heat shrink tubing. Slide heat shrink tubing up one wire BEFORE soldering. Slide down onto soldered connection of wire, heat ->heat shrink tubing

...heat-shrink that wiring to the vehicle wiring. I suggest you do 1 wire at a time so you don't get the wires crossed. Here what you do, If you bought the socket at the dealer it will come with ...

Question about x Interval 4G Waterproof Headphone System for the 4th Gen

3 Answers

...Heat-shrink tubing is ideal for this kind of problem. It's not sticky, doesn't come undone or bleed adhesive. You can put it over any wire. If you have a pair of bare wires, put one piece over one ...

Question about Gpi& Fuel Pump

1 Answer

...pieces of shrink wrap tubing on the wire before soldering. After soldering, I slide one over the solder joint and shrink it with heat, then slide the second one over the first and shrink it with

Question about Power 1800 Grill And Griddle Indoor Grill

1 Answer

heat shrink tubing, a heat gun (hair dryer will do) and a soldering iron. 1. Cut the cord where the chip is. 2. Strip the wire on both sides by about 1/8". You should have 4 exposed wires from the two

Question about Ac Adapter Liteon For Pa-1650-02 19v 3.42a 65w 1ca Mzm

1 Answer

heat shrink tubing which will fit over each individual wire as well as a piece that will fit over both wires which will be covered with the smaller heat shrink tubing. Once you cut out the bad portion

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Audio Players & Recorders Experts

 Grubhead
Grubhead

Level 3 Expert

5686 Answers

The Knight
The Knight

Level 3 Expert

76115 Answers

Marvin
Marvin

Level 3 Expert

85161 Answers

Are you an Audio Players & Recorders Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...