...sensor that when it reaches a certain termperature will turn on the fan. finally make sure the thermostat is installed correctly. I believe the part with the copper end that heats up and causes the ...
...plugs, TPS sensor, All oxygen sensors, crankshaft sensor, vaccum leaks etc.. CODE: oxygen sensor heating after catalytic converter sensor 4, mixture deviation, etc,. Could it be the DME (
...plugs, TPS sensor, All oxygen sensors, crankshaft sensor, vaccum leaks etc.. CODE: oxygen sensor heating after catalytic converter sensor 4, mixture deviation, etc,. Could it be the DME (
...heat or AC. The fuse is good. Switch show LED speed. What should I check for: - Blower resistor - Blower unit - Temperature sensor - Defect switch Has anyone runs across this problem? You have clean ...
...sensor systems don't clear when a new bulb is installed unless the bulbs are replaced as pairs (left and right sides at the same time even though one is still working). Try this first before trying ...
1996 328IS, Over heating after 25 minutes of idling, I have replaced the radiator, thermostat, water pump, fans are working, except blower for heater. after idling 20 to 25 minutes the coolant start ...
heat usually indicates low fluid level or restricted system. You can't just go by the coolant resivoir, a leak in the system will cause the system to use fluid and not draw the excess into the engine,
Usually answered in minutes!
543 Questions
221 Questions
49 Questions
4 Questions
