Questions & Answers for: Saab heat sensor

Ad

Question about 1993 900

3 Answers

...light comes on and the car shuts off once the car cools off it runs ok for another hour or so over heated Are you using Synthetic oil ( 5 w 40 synthetic) and have you totally flushed the radiator ...

Ad

...sensor can translate heat. Not allowing restart after the turbo heat radiates in the area. Try a wad of aluminum foil in front of the crank sensor(on the block behind the turbo) . It protects it from ...

Ad

I have a 2000 saab 9-3SE. When the motor heats up the speedometer quits working, the ABS light and brake light comes on and stays on. Also the winter light comes on and stays on. What could be the ...

Question about 2000 9-3 Viggen

1 Answer

...Low Voltage Bank 1 Sensor 1 (sensor is before the catalytic converter)Possible causes- Front Heated Oxygen Sensor Bank 1 harness is open or shorted - Front Heated Oxygen Sensor Bank 1 circuit ...

...right reversing light; high-mounted brake light;trailer lights11 - -12 - -13 - -14 - -15 15 Seat heating, left seat16 15 Seat heating, right seat17 7.5 Autodimming rearview mirror; rain sensor; ...

Question about 1998 900

1 Answer

...sensor, and the ECU will not switch on the fuel pump, so no gas and no go. Cheap part to replace. THEY DO FAIL WITH AGE. If the car has done a high mileage. Replace it. Age due to constant heat ...

.../low coolant level, gear box temperature over heat, loose position sensor/s . Run the fault codes first to determine where the faults are. Check that the cam shaft is turning ( broken timing

Question about 2004 9-3

1 Answer

what is dtc p0037 code p0037 refers to heated oxygen sensor(HO2S) 2 bank 1heater control--circuit low===causes wiring short to ground--HO2S-- ECM replace the sensor.

heat temp gauge on motor if faulty can it effect the cooling temp of the air conditioning on a saab 93 convertible 2002 model No. The engine temp sensor affects engine idle speed, and timing. There is

...- crank position sensor is the main culprit. The sensor goes out of calibration from heat and then goes back into an acceptable parameter once it's cooled off. A link to a Saab forum on the issue

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2004 Saab 9-3
2004 Saab 9-3

533 Questions

1999 Saab 9-5
1999 Saab 9-5

430 Questions

1997 Saab 900
1997 Saab 900

358 Questions

1995 Saab 900
1995 Saab 900

307 Questions

2001 Saab 9-3
2001 Saab 9-3

311 Questions

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85160 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...