unit, you will have to loosen 4 breather type hoses as well as the air intake line and the exhaust pre-heater, use a variety of Phillip heads screwdrivers at different lengths (a stubby and extra long
head unit similar to mount into the existing slot where the radio goes but all three told me the exact same thing: the head units mount on the side not on top or bottom. also i noticed when i got home
...head unit started to flash and the lights were dimming. I made it to a gas station where the truck died and would not turn over. I received a jump and the truck made it 100 yards started sputtering ...
...head and unplug the single wire temperature sending unit 10. Remove the upper half of the timing belt cover 11. Remove the valve cover 12. Disconnect the wiring harness connector that is just to the ...
unit. But It is a fuel issue. You are getting too much fuel into the engine. White smoke is sign of coolant going out the exhaust OE: bad head gasket. Check you coolant level. RE: Cost? you'll need to
unit..there may be a leak there as well.. any hairline craks anywhere..is the block surface free of any old gasket material that interferes with the replacement gaskets sealing? does the head have any
...head, 10 mm headed bolt holds the shield and the sensor in place, but is only used when trouble shooting misfires.) By Crank Case Sensor, I assume you mean Crank Angle Sensor. This consists of a disc ...
Usually answered in minutes!
829 Questions
564 Questions
428 Questions
367 Questions
319 Questions