...head "ford tuff" so I thought I would give it a try. Boy was that a mistake. I don't know how they ever get repeat customers. Junk Junk Junk Junk. Fix Or Repair Daily- Found On Roadside Dead. I could ...
head rest in locked position I put a rear facing carseat in the backseat of my 2008 Explorer. Before I tightened the seat belt I pulled the top strap behind the headrest, then proceeded to tighten it,
...rest remove it too and unplug it from the switch. Once eveything is undone from the panel then you are ready to pop the clips off. If yor lock button is down then the panel should slip over it or you ...
head gasket. The white smoke you are seeing is anifreeze burning. If it was blue smoke it would be burning oil. Gasket is in the top of the engine and must be replaced or you will ruin the rest of the
...rest you have a Blown Head Gasket or Cracked Cylinder or Head assembly. This type of situation needs to be repaired as soon as possible. is there whit smoke coming out the tale pip is the water ...
...going to start from the seat being upright in a normal riding position. 1. You need to fold the head rests first. Pull the black tab under both headrests. They should spring into a folded
How do you release the rear seat head rests in teh 2006 Ford Explorer? There is a small button on side of head rest that needs to be pushed in, in order to release the head rest.
Question about 1999 Explorer
...rest.and been driving for 20mins.and turned the heater on and it blows cold air and the temperture guage reads cold Best case scenario is your thermostat is stuck open. When this happens the engine ...
head rest seems to no hold the head rest up any longer, is that also a quick fix or should I take it in to get fixed? Thank you ;) There is a tube from the bottom of the fluid bottle going to the pump
Usually answered in minutes!
2,998 Questions
2,307 Questions
2,248 Questions
2,302 Questions
1,513 Questions