Questions & Answers for: Nissan head rest

head to have it refaced in the machine shop. my problem is how do you remove the timing chains to free the twin cams? can you also give me the valve clearance for this? You have to take apart the rest

...portion of the door panel. You need to locate any of these first and remove them. some screws/bolt heads may be hidden by small plastic caps which cover the heads. In some models, there is a piece

head screw driver and remove the arm rest pad by prying up on it, there is a couple of screws behind it, remove the power window switch bezel the same way you removed the armrest, and there is a screw

...head screws which are visible when you remove arm rest. Remove a plastic screw on rear edge of door located about 6 inches below window glass. Gently pry around edges of door panel to force plastic ...

rest is labor. Does this make sense to anyone? Sounds like the problem is in the speedo head itself, in the dash. If fuild was leaking, I don't think the speedometer would work either? Sounds like the

...rest is removal of intake and exhaust manifolds and head...bit more to it than that but, if it were overheated you may have to have the head machined, and pressure tested for cracks(aluminum) and use ...

where can i find head rests for my 2009 Nissan hardbody 2x3 (sanni) and the spanner for removing the spare weel Check Ebay you can save alot of $$$ going that route.

...rest on the dry test it could be rings/ scored bore and if it doesn't improve on the wet test then it will most probably be a valve or a valve seat insert most head gaskets show as adjacent cylinders ...

...have 2 steel poles going into the top pad of the back rest, there will be 2 tabs at the rods at the top of the seat around the rods that you press as you pull the head rest out. Best with 2

...rest of the day. Had head gasket,timing chain,tensioners, vvt solenoid, cam sensor replaced. I am 100 percent sure the timing is dead on. The car will give a p0011 code every morning I can clear the ...