head cover. 1) Install the cylinder head cover gasket to cylinder head cover. 3) Apply liquid gasket (TB1207B or equivalent) to the rubber seal of the camshaft end, injector harness gasket area and No
cover gasket, does the cylinder head gasket have to be changed at the same time. A valve cover does just that, covers the valves on the cylinder head. Barring an extremely unconventional design on the
...head cover retaining nuts Disconnect the PCV hose. Remove the six nuts and seal washers from the cylinder head cover. Loosen them in a crisscross pattern. Remove the cylinder head cover and the cover ...
...head cover gasket. I have a 1998 Tiger Shark 770 jet ski, blew out head cover gasket looking for the torque set for topside head cover, ft per inches or ft per pound. Suzuki Inside-out in a cross ...
...cover and cylinder head gasket mating surfaces. Install the valve cover on the cylinder head using a new gasket. Tighten the valve cover bolts to 14 ft. lbs. (20 Nm) in a crisscross pattern. Install ...
...Head Cover - REMOVAL & INSTALLATION procedure... 1. Remove the air cleaner assembly. 2. Disconnect the PCV hose(s) from the cylinder head cover. 3. Remove the nuts and washers. Lift the cover off ...
...head cover. Remove the cylinder head cover and the cover gasket from the cylinder head. Discard the gasket and replace with a new one. To install: With a wire brush or gasket scraper, remove all the ...
Question about 2006 Sierra 3500
1 TORX® head screw (1) in the upper trim cover (2) before removal. If necessary, remove 1 TORX® head screw (1) from the upper trim cover (2). If a screw is not present, remove the upper trim cover (2)
Question about 2004 Sienna
...HEAD COVER SUB-ASSY (a) Apply seal packing to the cylinder head as shown in the illustration. Seal packing: Part No. 08826-00080 or equivalent NOTICE: Remove any oil from the contact surface. ...
Question about 2004 Sienna
head cover. This gasket can be used again. 1. Disconnect the negative cable from the battery. 2. Disconnect closed ventilation system and evaporation control system from cylinder head cover. 3. Remove
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions