Scrapping sound I think a coin is behind the drum and it makes a scrapping sound when I spin the drum. Hugo likely something else like bra wire sticking up from drain hose rubbing basket. remove front
...He2 will do the final spin but part way through it will stop as the control panal goes blank, no blinking likghts or codes and then it won't open as the door is still locked. There is a water pump in ...
...washer tub shell. 4. Insert the upper shell support springs into the wash tub and support spring brackets. 5. Raise the washer casing to the upright position, making sure the tub does not swing ...
Question about HE2 Plus Front Load Washer
...HE2 front loading washer. I just I have a Kenmore HE2 front loading washer. I just moved and since it has been shaking violently during the spin cycle. Last night there was water on the floor, all of ...
...washer tub shell. 4. Insert the upper shell support springs into the wash tub and support spring brackets. 5. Raise the washer casing to the upright position, making sure the tub does not swing ...
...tub--you may notice that your washer has water in it when you haven't used it for a few days. To fix this, replace the valve. Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering ...
...the lid is closed. If the washer has not drained, it will not go into spin. Use a flashlight to inspect the holes in tub for foreign objects like screws, nails, bra wires, etc. and remove if
...HE2 Plus Front Load Washer The bearings at the large pulley are shot. Can I just replace the bearing or do I have to replace the back half of the outer tub? Can the bearing be replaced from the back ...
...tub underneath the washer. Make sure you unplug the wiring assembly from the drive. After you remove the 3 bolts , the motor will fall out.Remove the 2 metal screw from the clips holding assembly ...
...tub it will end up in the pump but most likely it's from the spider gear,i've seen this before,when it starts to pin fast gravity pins the broken part to the side but when you move the drum by hand ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions