Questions & Answers for: hazard relay

...hazard relay is located in the dash behind the triangle shaped switch that you are tapping on. The relay is actually 2 relays, one for the turn signal and the other for the hazard. The turn signal ...

...hazard relay or other, which has caused this problem. I can't find a solution in the manual, and cant afford a dealer tech. Since the turn signals work, do you think a relay or other device being out ...

...hazard relay to the turn signal relay.On the fuse block(right-hand side kickpanel just inside the r/hand door)the upper left relay is the turn signal relay.Bottom right is for the hazards.Hope this ...

...and run that by them to make sure thats common for that model too. If so, picking up a new Hazard switch should be relativley cheap and easy! Where is the hazard light relay LOCATED? Can't find ...

...Hazard Relay (not Hazard Flasher Relay). Basically the power to your Turn Signal flasher is fed from the Hazard Relay if your Hazard Switch is off, and when the Hazard Switch is ON, the Hazard Relay ...

...Hazard lights worked. Now, the blinkers will not even work intermittently. Hazards still work. Fuse for blinkers is good. Tried to replace the relay, but that caused the hazards to not work too, with ...

...relay is the turn signal/hazard flasher. relays 1 and 4 are switched system power relay 2 is accessory delay relay 3 is front blower motor relay 5 is rear defrost relay 6 is auxiliary blower motor ...

Hazard lights working but not blinkers Not sure of vehicle type, but most vehicles have two flasher relays. One for the turn signals and one for the hazards. The turn signal flasher is probably bad. ...

keep blowing and popping fuse. I have replaced fuses and relay once already. also hazard lights do not work either 1998 mitsubishi montero replace hazard light relay ,and hazard light switch if needed

...relay to the indicators. I have checked the hazard switch and all the fuses but can not locate the relay which I believe is a separate relay to the indicators. Does anyone know how to resolve this as ...