Question about Hayward Xstream Filter 150 Sq Ft, 1.5 HP Pump/Timer
...pool filter,model 244t to whom it may concern, a small 1/4" crack in center of the filter,i tried various water proof epoxy and glue from both inside and out,with a patch(inside).it worked for a few ...
Hayward sand filter needs primed every time I have had the pool for over 15 years. I just replaced the seal in the flow valve. every time I tern the filter off, the water in the lines runs back into ...
Question about EC-40 DE Pool Filter with pump
hayward pump wont prime. air bubbles coming back into pol with water and de You have a leak, if DE is getting back in pool your filter is either dirty and needs to be taken apart and throughly cleaned
...pool hayward filter and flo value one horse pump. When running in filter cycle water leaks out waste port YOUR HANDLE IS NOT SEATING IN THE RIGHT POSITION THERE IS A SPROCKET UNDER HANDLE THAT MAY BE ...
...hayward pool filter...any suggestions? Try consulting the the owners manual for these pool filters. They have a pretty good trouble shooting guide and it should be able to help you correct your ...
...a copy of the users manual for these pool filters. It has detailed illustrations about how the filter should be put together. ...
...Hayward VL series sand filter hooked up to an above ground intex soft sided pool. The pump/filter is lower than the suction hose connected to the pool. Once the pump is primed it runs, after a while ...
Question about HAYWARD HEAT PUMP HP2100TCO3T 112,000 BTU -
...filter position i am losing a little bit of water coming out of the waste and backwash pipe The gasket or o-rings on your backwash valve are leaking. Bring any part of your valve to a pool store and ...
Question about SAND FILTER, PRO SERIES
Hayward 220T pool filter is leaking water; could it be the multi-port valve needs to be replaced? Pool is leaking when filter is turned on. I have a Hayward 220T sand filter that is over 10 years old.
Question about SAND FILTER, PRO SERIES
...Hayward+Pro+series+S310S+leaking+at+seams Try applying JB Weld Epoxy putty. If you can drain it, remove the sand clean the seam and apply from the inside, it will last years, or from the outside, ...
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions