...away. How can I correct this? how are3 the gas cylinders...are they supporting the weight of the hatch? if there is a leak the cylinder cannot support the weight of the hatch itself causing it to ...
...is constantly on. Is there a door sensor on the hatch? If so, where is it located? there may be a mercury type switch on one of the shock supports that hold door open or its part of the latch
how do you remove the rear hatch on a 2000 plymoth voyager I supported the hatch and removed the hinges from the hatch.
Rear hatch door support piston lost fluid, hatch is hard to lift. Need to know how to change. Get replacement unit(s), find a support rod, release the clips or retainer on the old cylinder, and put in
2007 gm Yukon , hatch will start to open when activated but then stops itself before reaching the top and starts closing. Does not have any suspension to stay up by itself when opened and lifted ...
... If the rear hatch is the issue it's likely the rear strut supports that hold up the hatch are worn out. They can be bought from local auto parts stores...look on Youtube on how to replace them. ...
Question about 2000 Blazer
...hatch opens but tail gate will not come down Hi, check your lift supports or the hinges. If they're dented or bent, they might let the hatch open but not come back down. Here's a link with a picture ...
...Sounds like the hatch lift supports are bad. There are two and they are located on either side of the hatch. These may be purchased at most auto parts stores and are usually very easy to
Question about 2004 Murano
...of MS Windows 7 and up operating systems. You likely have software for the older XP system. is it hatch the name of the software you may need to contact software maker or buy a later version or ...
...Hi
Just buy new and replace1Pair Rear Liftgate Lift Supports Shocks ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
