Questions & Answers for: Ford F-150 hard to start when hot

Hard to start when engine warm Starter works fine and cranks engine, but it takes extended cranking ( approx 1 minuite or more for engine to start. This occurs only when engine is warm. When engine is

Hard starting when engine is hot My 1988 Ford f-150 6cyl with fuel injection. My truck is hard to turn over when engine is hot. what might be the problem If the engine is turning over hard and slow ...

...How do I change this light? Try turning the socket that holds the bulb to the left and pull it out to get to the bulb some times these get so hot that they start to melt so it might be hard to ...

...Start with the basics such as verify correct coolant level and water pump operation. Check air flow across condenser and radiator. It is easy to fold-over the cooling fins with high pressure at car ...

...on when hot and then trany starts to shift very hard? I CAN'T SOLVE THIS BUT CAN TELL YOU IF THIS TRUCK IS 2003 OR NEWER THE TRANY IS CONTROLED BY THE COMPUTER AND CAN BE TROUBLE SHOT BE A TRANY ...

...start up its still running on choke,,, fast tick over,,, when the choke comes off it starts to stall on you,,, yes? the tick over should be set at 750 - 850 rpm (in gear when hot) when makeing any ...

start barely cranks tried 2 batteries what could be the problem vehicle sitting outside no garage 10w 30 oil used could it freeze Check all wires and switch used to wire the push button ignition. Make

...Hard to start when hot. Have to crank engine for 30 seconds. Runs ok after starting. Check engine says it is running lean. Starts ok when cold. I have the same problem with my F150 4.6. Long cranking ...

...Hard start when cold, black smoke, rough idle. New plug/wires, air/fuel filter, low pressure fuel pump primes then cuts off/no restriction in lines, Techron fuel injector treatment added. Could it be ...

hot loses power at times and will die when idling. the check engine light comes on immediately when this happens and fuel pumps, checked wiring and fuses check all vacuum hoses for deterioration /hard