Questions & Answers for: Chevrolet S 10 happens car jumps timing chain

timing chain, its good. Piston goes up and down but no compression. Not enough play in the timing chain to jump. Any ideas? You could have a burnt valve if there is no compression in just one cylinder

...backfires what could this be I have duel ext from the muffler and a bigger cat that needs replaced but why does it backfire? its a 2.8L carb Either bad plugs , wires or timing is off, or chain

...timing chain, not a timing belt. Replacing it requires removing the water pump, dropping the oil pan, removing the balancer and timing cover. Rotate the crank so the dots on the cam gear and crank ...

timing chain or belt? if broken will valves hit pistons? if its a 2.2ltr its a timeing chain and the r known for failing they have a cheap plastic slide that wears out prematurely causing the chain to

won't start , back-firing through carberator 1997 carb??? Sounds like a timing issue. (Belt or chain jumped teeth)

...timing chain? I was having problems with it overheating some too. Your truck has a timing chain....Overheating can also occur if it has previously jumped a tooth on the timing gear. yes s-10 have ...

...stop cranking it starts deiseling if that is whats going on then yeah it prolly jumped time wich means your timing chain tensioner is prolly umm junk and you should prolly put a timing chain in it ...

engine cranks,but will not start.Its getting spark and fuel. what else could it be? Hi:) Did you check the timing if the timing chain jumped a tooth it will not start.and will backfire and sputter.

...timing chain on a 2000 astro 4.3, new chain is as loose as the original one, maybe 1/2 in of play, is this normal? i keep getting crankshaft and camshaft correlation code, distributer is set right as ...

...body It pops but doesnt start Jumped out of time due to worn timing chain or improperly set timing of crankshaft and camshaft. A bad coil, distributer cap or igniton module will definatly cause