Questions & Answers for: han release

...door does not open when pulling on the film advance knob to release the catch. Can it be repaired? Hans Persson Han[email protected] I used to use a Canon older than yours. So I'm guessing it ...

release the unlock button.The locks should cycle to confirm it is in the learn mode.Press han hold the lock and unlock buttons on the fob, after a 15 to 20 second delay the locks will cycle to confirm

...four stroke Howdy: There must be a suction pull on the vacuum line somewhere. A han pump must release the pressure every time it is pulled then pushed. Look for clogged release holes at the

...han you know you have a graphis card problem but if it does not work than you know that the monitor is the one with the problem It may have a faulty controle circuit on it and needs to be serviced or ...

...release roller as paper held so tight all prutruding has torn off Hi there Just try turning the rollers by han till you clean all out, if the roller is damaged then it not any use it will not print ...

...plate to release the pressure. If someone knows were I can find only the disk I will be happy. Hans ...

...release the freon. I brazed a service valve onto the line, but there is no plate inside fridge to tell me how many oz. of freon to add. Anyone have any ideas. I have done enough of these I could do ...

...a way to perform a reset? I already tried power off/on and disconnecting poower altogether - no change. Hello Hans! Welcome to FixYa!According to the manual of Canon Pixma MG 5250. Following steps ...

han nothing! cant get this man to do a thing about it, so i am! Hi, there is two possible problems, first off could be the tap jumper or there is air trapped in the pipes. Try replacing the tap jumper

...unlock switch. The doors will lock and unlock to confirm the program mode." Please notify! Tks, Hans Bad RKE module. Bad receiver, bad wire, bad transponder. Takes a scanner to see which is