ground wire going to the board hey guys i smoked my ground wire going to the board i must of had to small of wire or had it grounded at the wrong place the unit still works but i cant run my microwave
...ground wire, is this a power wire? How does it work without a ground? Or does the radio ground it automatically with the black wire plugged in to the ext speaker jack? The black wire goes in the ...
Question about 148 GTL 120-Channels Base CB Radio
...wire colors. pin 1 is ground. some mic's need two wires for ground depending on the PTT switch used. pin 2 audio. pin 3 TX pin 4 RX.. thats all there is too it. once you know the pins all radios are ...
Question about 148 GTL 120-Channels Base CB Radio
...ground wire on mike cord to corresponding # on mike jack. Once you have ground on proper pin then all else is elementary......use ohm meter to see which wires are TX and RX on mike.....last wire is ...
the back of the unit is the ground? I have a solid red wire and a black wire with a red stripe the black wire is ground. It only has a red strip because it was split from the red wire. Red is positive
...Make sure the device IS WELL GROUNDED. Sometimes you have to ground ALL the NEG. wires to a central point. This includes running a ground wire....# 12 - 14 directly to that same central
wire without do I hook both red and orange to hot and black to ground? it depends on what radio if you have a cobra 18wx style or maxon's, or a radioshack type the red is constant power 12v, orange is
Question about 148 GTL 120-Channels Base CB Radio
i need to no wich of the pins on mike are ground The outside metal around 4 or 5 pins is usually ground. Black wires indicate ground.
Question about 148 GTL 120-Channels Base CB Radio
...plug and one will terminate to ground. Most likely on a board, where you may have to trace that wire to the chassis, which is ground. Most likely, they are color coded. Black is ground, red is
Question about 148 GTL 120-Channels Base CB Radio
...Ground) Red wire to Pin 3 (Transmit) Black wire to Pin 4 (Receive) Solder each wire to its corresponding pin on the microphone jack. You may want to use a multimeter to verify that each connection is ...
Usually answered in minutes!
29 Questions
5 Questions
0 Questions
1 Questions